Watts, amps and volts calculator
Know any two of watts, amps and volts? This worksheet finds the third, for direct current and for single-phase alternating current. You type the voltage from your own label or meter — readers in North America and Europe alike — because this page assumes no grid, plug or battery voltage for you.
Method
For DC, real power = volts × amps (W = V × I). For single-phase AC, real power = RMS volts × RMS amps × power factor (W = V × I × PF), while apparent power = RMS volts × RMS amps (VA = V × I). Power factor is the ratio of real to apparent power, so watts are at most the VA figure and equal it only at a power factor of 1. Solving for amps divides watts by (volts × power factor); solving for volts divides watts by (amps × power factor); the power factor term is omitted for DC. The divisor must be more than zero, which is why the form asks for a positive voltage when solving for amps and a positive current when solving for volts.
Worked examples
- DC battery circuit, example assumption: 12 V and 10 A gives 12 × 10 = 120 W.
- AC example using a 230 V input (an example, not an assumption about your supply): 230 V, 5 A, power factor 0.8 gives 230 × 5 × 0.8 = 920 W real power and 230 × 5 = 1,150 VA apparent power. Turned around, 920 W at 230 V and 0.8 gives 920 ÷ (230 × 0.8) = 5 A.
- AC example using a 120 V input (also just an example): 120 V, 12 A, power factor 1 gives 1,440 W.
Every number above is an entered example. Your supply, battery and devices have their own actual figures — read them from labels or a meter rather than copying an example from another country or system.
Limitations
- This converts between units at one operating point. It is not a wire, breaker, fuse or socket suitability tool, and it does not size circuits or equipment. Whether a load may be connected somewhere depends on ratings, standards and installation conditions that this page does not assess — check equipment manuals and, for fixed wiring, a qualified electrician.
- AC results assume the single power-factor figure you entered stays constant. Real devices can draw varying current, and starting or surge current can far exceed a running figure; neither is modelled here.
- Label watts are sometimes a maximum rather than a typical draw. A plug meter reading under your normal use is usually the better input.
Sources
Unit definitions for the watt, volt and ampere follow the BIPM SI definitions and the NIST Guide to the SI, Appendix B.8. The definitions of apparent power as volts × amps (VA) and of power factor as real power ÷ apparent power follow the U.S. Energy Information Administration glossary, with general background in Measuring electricity.